Diy Pulley Tensioner
Here's an update version of my Diy Pulley Tensioner or Pulley Idler
I will be using the HB Cyclone-S pulley for this project
you can get them here
Cut the side knob and sand it down even
You need a 1/4 drill bit to bore for an opening
for the flanged bearing about 2mm deep
Flanged bearing size 3x6x2.5mm
you can get them here
Test the flanged bearing into the pulley
then repeat process to the other side
Here's the 3racing belt tension available here
Final assembly
No comments:
Post a Comment